<button id="qs2qz"></button>
<form id="qs2qz"></form>
<button id="qs2qz"><object id="qs2qz"></object></button>

    1. Welcome to Baoji Zhongpu Non-Ferrous Metals Co., Ltd.

      Today Is:

      Position:

      Home >> NEWS >> Company News


      Cutting essentials of niobium rod, niobium tube and niobium processed workpiece

      Niobium has low strength, low hardness and high toughness, with good cold plasticity. In the cutting process, with the increase of temperature, oxygen and nitrogen are absorbed, which has a significant effect on the properties of niobium. Baoji Zhongpu provides: tantalum board, tantalum rod, tantalum tube; Therefore, the main problem of cutting niobium is to prevent cutting temperature is too high, requiring the use of sharp tools, low cutting speed, and pouring a lot of cutting fluid.

      Cutting niobium cutting tool materials can be used high speed steel or YG8, YW2 and other hard alloy, but it is not suitable to use hard alloy containing niobium as tool material. When using carbide tools, the geometric parameters of the tools can be selected as follows: γO=20o ~ 25o,αO=10o ~ 15o, KP R = 45O, KP R = 15O,γO1= -5O ~ 0O, B γ=0.1 ~ 0.3mm, R ε=0.2 ~ 0.5mm. Radius of chipping trough =4 ~ 6mm. The leading Angle and main deflection Angle should be appropriately increased while finishing, and the radius of tool tip arc should be reduced. Baoji Zhongpu provides: tantalum board, tantalum rod, tantalum tube; Niobium plate, niobium rod, niobium tube cutting amount of choice as follows: rough processing when ν C =45 ~ 80m/min, AP =5 ~ 8mm, F =0.3 ~ 0.5mm /r; Semi-finishing when ν C =60 ~ 100m/min, AP ≤2mm, f=0.2 ~ 0.4mm/r; When finishing, ν C =70 ~ 120m/min, AP =0.1 ~ 0.5mm, F =0.1 ~ 0.15mm /r. Using high-speed steel tool, ν C ≤30m/min, F ≤0.3mm/r.

      http://www.gestosoft.com

      av黄色网站免费观看,免费色片网页大全,熟女福利一区二区三区,天堂av在线直播

      <button id="qs2qz"></button>
      <form id="qs2qz"></form>
      <button id="qs2qz"><object id="qs2qz"></object></button>